Aviation Safety

In the May 2019 issue, I couldnt help but note the connection between Key Dismukes article Stress in the Cockpit and Mr. Burnsides observations in Cockpit Communication. When there is poor communication in the cockpit, stress levels are going to rise. It doesn’t matter if the communication shortfall takes place in the air or on the ground. Two of the four categories of errors made by airline crews that were pointed out by Dr. Dismukes were inadequate comprehension, interpretation, or assessment of a situation, and inadequate communication. These categories are faithful descriptions of the failure to explicitly define and communicate expectations that your friend experienced with his flight instructor.

The FAA defines a hot spot as a location on an airport movement area that demands heightened attention by pilots and vehicle operators due to the history of potential collision or runway incursion. Knowing where any hot spots are at the airports you intend to use arms you with useful risk management information. Meanwhile, the FAA has gone sort of nuts with the airport hot spot concept. Dont believe me? Check out the airport diagram for Addison Airport (KADS) in Dallas, Texas, below. Every taxiway intersection east of the runway is a hot spot.

Once again, the Experimental Aircraft Association in July pulled off another great AirVenture fly-in at its home in Oshkosh, Wis. This years event had a little of everything, including torrential rain the Friday evening before Mondays opening day, nighttime air shows and lots of airplanes of every shape, size and purpose. Perhaps because the pre-show rain knocked everyone off-kilter-followed by mid-week heat-the overall event seemed to need more cowbell, but it definitely was worthwhile checking out all the new stuff and checking in with long-time friends.

A witness observed the accident airplane at about 30 feet agl without its landing gear extended, and it was not extended when the airplane began to flare. Examination revealed the runway surface showed striated gouges and two long skid marks tracing the airplanes path from the runway.

Pilots are taught to take off and land into the wind, and avoid landing or departing with a tailwind. There is a reason: The performance penalty of a tailwind is much greater than the benefit of a headwind. How big a penalty? Go to your POH and calculate it. The most common figure is to add 10 percent to the takeoff or landing roll for every two knots of tailwind up to 10 knots. The specific penalty will vary based on a number of factors like runway surface, density altitude, and gross weight. Somewhere down in the fine print, you may see an additional penalty for runway slope. But often runway slope is neglected, because most runways are level.

A long-time pilot-friend of ours tells a story about his first check ride for the commercial certificate. Everything was going relatively well until the examiner asked him to perform the eights on pylons maneuver. His response was something along the lines of, Yes sir, thank you, sir, and what altitude would you like, sir? The examiner ended the check ride and told him to come back after talking with his instructor about pivotal altitude. When he did, he learned that the correct pivotal altitude for a given groundspeed allows a banked line of sight from the cockpit directly parallel to the lateral axis of the aircraft to the pylon, a stationary object on the ground. Our friend went on to be one of the first pilots to fly the Airbus A300 in the U.S., for Eastern Airlines.

The SAIB is focused on ELTs from ACR Electronics, Inc. (ACR, formerly Artex Aircraft Supplies, Inc., and Chelton Avionics, Inc.), models G406-4, C406-1, C406-1HM, C406-2, C406-2HM, C406-N and C406-NHM. According to the agency, these ELTs may not transmit alert and location signals in the case of an accident involving an aircraft to which they are mounted due to an inoperative or a deteriorated G-switch. The SAIB states that an ELT mounted in a high-vibration environment, for example in the tail of a helicopter, could have its acceleration sensor deteriorate after having been subjected to high levels of shock and vibration for five years or more. The new SAIB recommends best practices for the inspection, modification and replacement of these ACR ELTs located in high-vibration environments. In our view, these recommendations can be applied to similar ELTs from other vendors.

When we approached the centerline, she nudged me on the shoulder. I rolled the plane to where I thought the runway centerline was. At this point we were totally in the soup, and I was flying by training instinct. I saw the ADF needle swing to the rear, indicating wed passed the outer marker, and I initiated a standard approach descent of 500 fpm, as I figured that would keep us close to the glideslope.

After installation of a factory-rebuilt engine, a ground-run was performed. At all settings, the engine ran too rich, and adjustments had no effect. Aircraft was not airworthy. Removed fuel servo from engine, sent out for repair. Reinstalled fuel servo after repair, and engine performed satisfactorily. Returned aircraft to service.

Its not unheard of to think thunderstorms are only a product of summer weather, like were experiencing now in the Northern Hemisphere. Certainly they are more common in warmer months, but wintertime thundersnows are common enough that Ive seen a few. The point is that we can encounter thunderstorms any time of year, not just in the summertime. The kinds of weather Mike Hart discussed in last months article, Air Mass Storms, principally are warm-weather phenomena, while thunderstorms associated with frontal activity can be experienced year-round.