Miscellaneous Aircraft Randolph Tank Sealing Compound While an unspecified aircraft was undergoing renovation, a steel fuel tank was sealed using a Randolph Aircraft Products sloshing compound. Ten months after being put back into service, the aircraft had accumulated 6.0 hours without abnormalities. Shortly after the next takeoff, the engine quit. The pilot landed on the remaining runway but the aircraft was substantially damaged. Investigation revealed the sloshing compound had failed and flaked off the tanks interior, clogging the fuel line. In response to another accident involving one of its products, Piper Aircraft issued Service Bulletin 251D, dated April 7, 2009, which recommends removing and replacing a fuel tank treated with this product and installed in any PA-28-, PA-32- and/or PA-34-series aircraft. Part Total Time: 6.0 hours Cessna 172M Stuck Starter Contactor The engine starter contactor (p/n 111-138D) stuck in the closed position. Once the master switch was energized, the starter motor would immediately engage. The master switch had to be turned off to stop the starter-and the propeller-from turning. According to the submitter, the defect seems to coincide with the use of high-torque starters. Part Total Time: 144.0 hours Cessna 310 Failed Landing Gear Rod End A main landing gear lock assembly (p/n 0841000-58) rod end (p/n HM-4) broke when the pilot attempted to extend the landing gear in flight, resulting in a gear-up landing. Inspection revealed the rod end had cracked prior to the event flight. A probable cause was fatigue failure due to the age of the component. Proactive replacement, based on time in service, was recommended. Part Total Time: 3688.7 hours Piper PA-31-350 Electrical Power Failure Loose battery cables led to a complete loss of electrical power while in level flight, IFR at 13,000 feet. Loose cables (p/n 80009-04) caused loss of the aircrafts battery power. When the alternators were unable to carry the load, it resulted in a total electrical loss. Part Total Time: unknown Continental IO-360-G2B Stretched Cylinder Studs During engine final assembly, many cylinder studs (p/n: 643651-1) seemed to be pulling from the case rather than achieving the proper torque. A cylinder was removed, revealing stretched studs. The studs center portions were obviously elongated and narrowed. The studs stretch at between 220-350 inch-pounds of torque, well under the specified final value. Part Total Time: unknown.
Sloshed
Key Takeaways:
- A Randolph Tank Sealing Compound failed after only 6 hours, flaking off and clogging the fuel line, causing engine failure and prompting a Piper Service Bulletin for specific aircraft models.
- A Cessna 310 suffered a gear-up landing due to fatigue failure of a main landing gear rod end, emphasizing the recommendation for proactive replacement based on age.
- Loose battery cables caused a complete electrical power failure in a Piper PA-31-350 during IFR flight.
- Continental IO-360-G2B engines were found with cylinder studs that stretched prematurely during assembly, indicating a potential manufacturing defect.
Key takeaways sponsored by Aviator Pro | Start Your Training ->
See a mistake? Contact us.
