The Twin Comanche was destroyed and both persons aboard fatally injured when the airplane impacted terrain while conducting a nighttime VOR/DME approach to Runway 23 at Uinta County-Burns Field, Evanston, Wyo. A pop-up IFR flight plan had been filed over Heber City, Utah; the flight originated at Panaca, Nev. At 2112 local time, the airplanes last position was 1 miles west of the airport at 7700 feet. At 2340, after ATC alerted local authorities that the flight plan had not been closed, airport personnel located the airplane approximately 150 yards northeast of Runway 23. Reported weather at the time of the accident included visibility 1 statute mile, light snow, mist; scattered clouds at 200 feet AGL and an overcast at 600 feet.
May 23, 2004, Evanston, Wyo. / Piper PA-30
The Twin Comanche was destroyed and both persons aboard fatally injured when the airplane impacted terrain while conducting a nighttime VOR/DME approach to Runway 23 at Uinta County-Burns Field, Evanston, Wyo. A pop-up IFR flight plan had been filed over Heber City, Utah; the flight originated at Panaca, Nev. At 2112 local time, the airplanes last position was 1 miles west of the airport at 7700 feet. At 2340, after ATC alerted local authorities that the flight plan had not been closed, airport personnel located the airplane approximately 150 yards northeast of Runway 23. Reported weather at the time of the accident included visibility 1 statute mile, light snow, mist; scattered clouds at...
Key Takeaways:
- A Twin Comanche crashed during a nighttime VOR/DME approach to Uinta County-Burns Field, Evanston, Wyoming, resulting in the destruction of the aircraft and two fatalities.
- The airplane impacted terrain approximately 150 yards northeast of Runway 23 after its last known position was 1 mile west of the airport at 7700 feet.
- Reported weather at the time of the accident included 1 statute mile visibility, light snow, mist, and low ceilings (scattered at 200 feet AGL and overcast at 600 feet).
Key takeaways sponsored by Aviator Pro | Start Your Training ->
See a mistake? Contact us.
