At approximately 1745 central time, a Cessna 150 lost partial engine power and crashed during the ensuing forced landing near Fort Worth. The pilot was not injured. The pilot said he was climbing through 50 feet agl when he noticed the engine starting to lose power. He continued to climb and flew a traffic pattern, turning to downwind at about 200 feet agl. He elected to land in a field ahead of him about a half-mile east of the runway. An FAA inspector reported the mixture control rod had separated from the carburetor.
June 07, Fort Worth, Texas / Cessna 150
At approximately 1745 central time, a Cessna 150 lost partial engine power and crashed during the ensuing forced landing near Fort Worth. The pilot was not injured. The pilot said he was climbing through 50 feet agl when he noticed the engine starting to lose power. He continued to climb and flew a traffic pattern, turning to downwind at about 200 feet agl. He elected to land in a field ahead of him about a half-mile east of the runway. An FAA inspector reported the mixture control rod had separated from the carburetor....
Key Takeaways:
- A Cessna 150 experienced partial engine power loss shortly after takeoff, leading to a forced landing near Fort Worth.
- The pilot was uninjured in the incident, despite the aircraft crashing during the landing attempt.
- Investigation by an FAA inspector determined the cause was the mixture control rod separating from the carburetor.
Key takeaways sponsored by Aviator Pro | Start Your Training ->
See a mistake? Contact us.
