Cessna172

At about 22:15 Pacific time, a Cessna 172C lost engine power during an attempted go-around and crashed off the departure end of the runway at Corona Municipal Airport. The three occupants were not injured. The student pilot, who owned the airplane, said he switched the fuel selector to the BOTH position about 5,500 feet over Ontario, verifying its position by feel. On short final he noted that they were too high and too fast, so he initiated a go-around. The engine did not respond to a power application. Witnesses who arrived on the scene immediately noted there was fuel in both tanks. Investigators later found the fuel line to the gascolator was broken at the attach point (possibly from imp…

At 11:15 central time, the pilot of a Cessna 172L lost control on takeoff and struck a runway end identifier light control box. The pilot was not injured. The pilot said his seat slid back as he was trying to attach a GPS to his leg during the takeoff run. The airplane went off the left side of the runway and struck the box. The pilot aborted the takeoff, then departed in the airplane and flew to Kenosha….

At about 1935 eastern time, a Cessna 172P crashed into the ocean while on approach to Ocean City Municipal Airport. Two passengers died and the pilot and a third passenger were not recovered. Another pilot said he was approaching the airport at the same time as the accident airplane. The accident pilot called Unicom looking for a taxi, but the witness pilot told him the airport closed at sunset and hed have to get a taxi when he landed. The witness pilot saw the accident pilot make the turn to downwind for runway 20 and, as he neared the departure end of runway 14, the airplane went from horizontal flight to vertical. The witness pilot said it was a clear but dark night….

At 1100 Pacific time, a Cessna 172M porpoised on landing at Catalina Island Airport, damaging the firewall. The pilot and three passengers were not injured. The pilot said the approach was normal. The flap position indicator ceased to function during the flight and the pilot estimated that he used 20 degrees of flaps for the approach and landing. He said that once he had the runway made, he reduced the throttle to idle and flared. The engine continued to produce power, running at 1,200 to 1,600 rpm and the airplane bounced several times as he tried to get it to settle on the runway. Finally, he pulled the mixture to kill the engine. The engine had accumulated only 17 hours of operation….

At 1407 mountain time, a Cessna 172L suffered a propeller blade failure during departure from Bullhead City/Laughlin International Airport. The student pilot landed on the remaining runway and overrun area. Neither the pilot nor his passenger was injured. Control tower personnel said the airplane had climbed to about 800 feet when the airplane experienced the failure. Preliminary examination revealed a disintegrated propeller hub with loss of propeller blades and a severed crankshaft aft of the shaft flange. The pilot reported that about 1 year prior to the accident, he and his instructor struck a bird during cruise flight. They made a dead stick landing into an airport, where they found t…