The FAA recently published an airworthiness directive—2020-26-16—covering many single-engine Pipers that carry either a PA-28 or PA-32 model number. “This AD was prompted by a report of a wing separation caused by fatigue cracking in a visually inaccessible area of the lower main wing spar cap,” the directive said. “This AD requires calculating the factored service hours for each main wing spar to determine when an inspection is required, inspecting the lower main wing spar bolt holes for cracks, and replacing any cracked main wing spars. The FAA is issuing this AD to address the unsafe condition on these products,” adding that failure to comply with the directive could lead to failure of a main wing spar.
FAA Publishes AD on Corrosion For Many PA-28 and PA-32 Aircraft
Key Takeaways:
- The FAA issued Airworthiness Directive (AD) 2020-26-16 for single-engine Piper PA-28 and PA-32 models due to a reported wing separation caused by fatigue cracking in the lower main wing spar cap.
- The AD mandates calculating factored service hours, inspecting lower main wing spar bolt holes for cracks, and replacing any cracked spars to prevent main wing spar failure.
- The directive also requires inspecting main wing spars for corrosion, allowing for flexible access methods such as existing panels, borescope use, or installation of new panels, rather than solely mandating new panel installation.
Key takeaways sponsored by Aviator Pro | Start Your Training ->
See a mistake? Contact us.
